The correct command to name vlan 35 as dhcp_vlan

In network management, VLANs (Virtual Local Area Networks) are critical for segmenting network traffic, improving safety, and optimizing overall performance. Naming VLANs appropriately can make community control more the correct command to name vlan 35 as dhcp_vlan  intuitive and green. If you’re running with VLAN 35 and want to name it dhcp_vlan, this newsletter will manual you via the right command to perform this venture on a Cisco transfer, which is one of the maximum common networking gadgets.

Understanding VLANs

Before diving into the command, it is important to recognize what VLANs are and why naming them matters:

• VLAN (Virtual Local Area Network): VLANs allow network directors to phase a single physical network into more than one logical networks. the correct command to name vlan 35 as dhcp_vlan  This segmentation can improve network performance, enhance protection, and simplify control.
• Naming VLANs: Giving a VLAN a descriptive name allows directors quick perceive the purpose of the VLAN, making troubleshooting and community management easier.

The Command to Name VLAN 35 as dhcp_vlan

On Cisco switches, VLANs are managed using the command-line interface (CLI). To call VLAN 35 as dhcp_vlan, observe these steps:

1. Access the Cisco Switch CLI:

• Connect to the switch thru console, SSH, or Telnet.
• Enter privileged EXEC mode through typing permit and imparting the important password.

bash
Copy code
Switch> enable

1. Enter Global Configuration Mode:

• Enter worldwide configuration mode to make adjustments to the transfer’s configuration.

bash
Copy code
Switch# configure terminal

1. Select VLAN 35:

• Use the vlan command observed through the VLAN ID to pick out VLAN 35.

bash
Copy code
Switch(config)# vlan 35

1. Name VLAN 35 as dhcp_vlan:

• Use the name command to assign a descriptive call to the VLAN. In this situation, we can call it dhcp_vlan.

bash
Copy code
Switch(config-vlan)# name dhcp_vlan

1. Exit Configuration Mode and Save the Configuration:

• After naming the VLAN, go out the VLAN configuration mode by typing exit.
• Save the configuration to make certain that the changes are retained after a reboot.

bash
Copy code
Switch(config-vlan)# go out
Switch(config)# exit
Switch# write memory

1. Alternatively, you could use the reproduction strolling-config startup-config command to shop the configuration:

bash
Copy code
Switch# copy strolling-config startup-config

Verification

After finishing the steps above,  the correct command to name vlan 35 as dhcp_vlan you could verify that VLAN 35 has been correctly named through using the show vlan quick command:

bash
Copy code
Switch# show vlan short

This command will show a list of VLANs and their associated names. You have to see VLAN 35 listed with the name dhcp_vlan.

Conclusion

Naming VLANs with descriptive labels like dhcp_vlan makes network control more sincere and helps with figuring out the cause of each VLAN at a glance. By following the steps mentioned above, you may without problems  the correct command to name vlan 35 as dhcp_vlan name VLAN 35 as dhcp_vlan on a Cisco transfer, ensuring that your network remains organized and efficient.